Industries
Data Centers
Take control of your roof integrity.
Every system in a data center is engineered for redundancy: power, cooling, connectivity.
But the roof, the one element protecting everything beneath it, is designed with no mechanism for ongoing control.
It is installed once, and assumed to perform.
The risk starts after installation.
Rooftop equipment and penetrations
HVAC, cables, generators, solar panels. Each intervention introduces new breach risk.
Ongoing foot traffic and maintenance
Regular access introduces friction, tools, and stress directly onto the waterproofing.
No verification in place
No method confirms waterproofing integrity before and after any of these activities.
Flood testing
Flood testing isn't a reliable test
- It is slow, inaccurate and risky.
- It cannot be repeated over time.
- It does not locate breaches, only confirms water found a path.
It provides no long-term control.
Buried systems
Covering waterproofing is not a solution.
- It does not prevent leaks.
- It hides the waterproofing and remove control.
- In case of failure, detection and repairs are often disruptive and very costly.
The risk is not removed. It is concealed.
Testability, built in from the start.
Controlit Leak Prevention layer is integrated directly under the waterproofing membrane. It creates a permanent conductive layer, enabling Electronic Leak Detection (ELD) at any point in the building’s life:
- Test after installation
- Test before handover
- Test after any intervention
Find breaches before they become leaks.
The result
Accurate and repeatable testing
Verify integrity at any time, with immediate results.
No reliance on flood testing
Removes slow, disruptive and risky methods.
Faster construction
Test on demand without slowing schedule or disrupting operations.
Continuous control
Proof of integrity from construction through the full lifespan of the facility,
Active Monitoring
From periodic testing to continuous control.
Testable waterproofing gives you a verified snapshot on demand. For a data center — where the cost of a single moisture event can exceed the cost of the entire roof — a snapshot is not enough.
Wireless into® sensors embedded inside the building assembly measure moisture, humidity, and temperature continuously. The moment conditions deviate, the right people are alerted — before damage reaches equipment.
Combined with Controlit testable waterproofing, this is Full Roof Control: permanently testable, actively monitored, fully protected.
Learn about monitoring →Continuous, not periodic
Sensors run 24/7. Alerts trigger immediately, not at the next scheduled inspection.
Inside the assembly
Visibility where surface inspection cannot reach — inside the roof build-up, not on top of it.
Audit trail for compliance
Historical data and trend reports document roof condition across the full facility lifespan.
Make your roof testable.
Work with us to design a roof you can test at any time.
Talk to us about your project